Step 1 – Download the Button Capture Software
Go to: https://www.mouthwatch.com/intraoral-cameras/getting-started/ and download our Button
Capture Software.
- View the installation guide
- Install the program, following all steps in the guide
Important: If setting up a MouthWatch Plus+ make sure to install the required driver by
checking the box at this step:
- Select Custom Keystrokes from the Button Capture Software menu, in the first blank
sequence area, press Enter on your keyboard to fill the area with the word Enter.
Step 2 – Plug in the MouthWatch Camera
Make sure that you plug the USB connector into a powered USB port. Sometimes, these are
located on the front or back of the computer. If your monitor has USB ports, these may not be
powered.
If setting up a MouthWatch Plus+ use a USB 3.0 port.
Step 3 – Windows Recognizes the Camera
Once the MouthWatch camera is plugged in, you should see a small alert on the bottom saying
that New Hardware USB Video Device was recognized.
Step 4 – Set Infinitt settings as below.
Step 5 - Launch the camera using this Icon and you are all set!