Instructions for DTX Studio Integration
MouthWatch cameras easily integrate with DTX Studio imaging software. Use the MouthWatch camera to capture images of the patient and store them directly into the patient record.
Step 1 – Download the Button Capture Software
- Go to: https://www.mouthwatch.com/intraoral-cameras/getting-started/ and download our Button Capture Software.
- View the installation guide
-
Install the program, following all steps in the guide
Important: If setting up a MouthWatch Plus+ make sure to install the required driver by checking the box at this step:
-
- Once you install the software, right click on the MouthWatch Capture icon in the lower right corner of your screen
- A menu will display. Select Custom Keystrokes from the list and press your Enter key to fill in the field with "Enter" as shown below then click save.
-
Quick Tip: If you don’t see the MouthWatch Capture icon, click the ^ button (indicated by the red arrow in the photo below) to expand the System Tray. You can drag and drop the icon from the expanded System Tray down to your Taskbar.
-
Step 2 – Plug in the MouthWatch Camera
Make sure that you plug the USB connector into a powered USB port. Sometimes, these are located on the front or back of the computer. If your monitor has USB ports, these may not be powered.
If setting up a MouthWatch Plus+ use a USB 3.0 port.
Step 3 – Windows Recognizes the Camera
Once the MouthWatch camera is plugged in, you should see a small alert on the bottom saying that New Hardware USB Video Device was recognized.
Step 4 – DTX Studio
Select your patient and then click "Capture" from the top tool bar of DTX Studio
- Select MouthWatch from the devices shown.
- The camera will launch and you can begin taking photos of your patient.
Step 5 - All Set!