Instructions for TigerView Integration
MouthWatch cameras easily integrate with TigerView imaging software. Use the MouthWatch camera to capture images of the patient and store them directly into the patient record.
Step 1 – Download the Button Capture Software
- Go to: https://www.mouthwatch.com/intraoral-cameras/getting-started/ and download our Button Capture Software.
- View the installation guide
- Install the program, following all steps in the guide
- Select TigerView from the Button Capture Software menu
Step 2 – Plug in the MouthWatch Camera
Make sure that you plug the USB connector into a powered USB port. Sometimes, these are located on the front or back of the computer. If your monitor has USB ports, these may not be powered.
Step 3 – Windows Recognizes the Camera
Once the MouthWatch camera is plugged in, you should see a small alert on the bottom saying that New Hardware USB Video Device was recognized.
Step 4 – Launch TigerView Administration
Open the TigerView Administration program from the TigerView folder in your Start Menu
Step 5 – Configure Acquisition Hardware
When you launch the Administration program, you will start on this screen:
- Select Acquisition Hardware Configuration
- Click Next
- Select Video Capture
- Click Finish
Step 6 – Take Intraoral Photos
- Select the patient record
- Then, click on the Acquire tab
- Then, select Video
- Make sure the Capture Device is set to USB Video Device
- Make sure Size is set to 640x480
Step 6 – All Set!
As you click the capture button on the MouthWatch camera, thumbnails will appear along the bottom. Select which you want to save and then click Save.
Make sure the MouthWatch Capture Button software running in the system tray and set to TigerView.
Comments
0 comments
Please sign in to leave a comment.